Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Result of CAN V1 Bus Check 
Symptom
Suspected Area
See page
Open in CAN Main Wire
CAN Main Bus Line
Click here
Short in CAN Bus Lines
CAN Bus Line
Click here
Short to +B in CAN Bus Line
CAN Bus Line
Click here
Short to GND in CAN Bus Line
CAN Bus Line
Click here
Open in One Side of CAN Branch Line
CAN Branch Line
Click here

HINT:
Refer to How to Proceed with Troubleshooting for the CAN V1 bus check procedure.


Communication Stop Mode Table 
Symptom
Suspected Area
See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester
Skid Control ECU Communication Stop Mode
Click here
"Air Conditioning Amplifier" is not displayed on the intelligent tester
Air Conditioning Amplifier Communication Stop Mode
Click here
"Power Steering (EPS)" is not displayed on the intelligent tester
Power steering ECU Communication Stop Mode
Click here
"CAN Gateway1" is not displayed on the intelligent tester (w/ Blind Spot Monitor System)
Gateway ECU Communication Stop Mode
Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on the intelligent tester
Steering Angle Sensor Communication Stop Mode
Click here
"ECM (Engine)" is not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
"Main Body" is not displayed on the intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on the intelligent tester
Combination Meter ECU Communication Stop Mode
Click here
"Airbag" is not displayed on the intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here
"Suspension Control (Air Suspension)" is not displayed on the intelligent tester (w/ Air Suspension System)
Suspension Control ECU Communication Stop Mode
Click here
"Four Wheel Drive Control" is not displayed on the intelligent tester (for 4WD)
4WD Control ECU Communication Stop Mode
Click here
"Accessory Gateway" is not displayed on the intelligent tester (w/ Bus Buffer ECU)
Bus Buffer ECU Communication Stop Mode
Click here