Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > Power Back Door cannot be Operated Using Any Switch

for Preparation Click here


DESCRIPTION

When the power back door cannot be operated using any switch, one of the following may be the cause: 1) initialization of the power back door ECU, or a malfunction in the 2) power back door touch sensor circuit, 3) back door closer system, 4) meter/gauge system, 5) main body ECU (instrument panel junction block LH), or 6) power back door drive unit (power back door ECU).

WIRING DIAGRAM


B251330E02


INSPECTION PROCEDURE

1.INITIALIZE POWER BACK DOOR ECU
  1. Check that the power back door drive unit (power back door ECU) can be initialized (Click here).


NEXT


2.CHECK POWER BACK DOOR SYSTEM
  1. Check the power back door system operation.

    OK:
    Power back door system operates normally.



NG
Go to step 3
OK

END 

3.CHECK BACK DOOR CLOSER SYSTEM
  1. Check the back door closer system operation (Click here).



NG
GO TO BACK DOOR CLOSER SYSTEM (Click here)
OK


4.CHECK COMBINATION METER
  1. Check the A/T shift position indicator operation.

  1. Check that the speedometer indicates 0 km/h (0 mph) when the vehicle is stopped and the engine idling.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


5.CHECK DTC OUTPUT
  1. Check for the DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    B2250 is output
    B
    B2251 is output
    C



B
GO TO DTC CHART (Click here)

C
GO TO DTC CHART (Click here)
A


6.READ VALUE USING INTELLIGENT TESTER (BACK DOOR LOCK)
  1. Connect the intelligent tester to the DLC3

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Open
    Back door lock / Permit or Prohibit
    Permit: Back door is unlocked
    Prohibit: Back door is locked
    -

    OK:
    The back door functions as specified in the normal condition.



NG
REPLACE MAIN BODY ECU
OK


7.READ VALUE USING INTELLIGENT TESTER (POWER BACK DOOR TOUCH SENSOR)
  1. Connect the intelligent tester to the DLC3

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Back Door / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Back Door 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PBD Touch Sen L
    Power back door touch sensor LH signal / ON or OFF
    ON: Power back door touch sensor LH pressed
    OFF: Power back door touch sensor LH not pressed
    -
    PBD Touch Sen R
    Power back door touch sensor RH signal / ON or OFF
    ON: Power back door touch sensor RH pressed
    OFF: Power back door touch sensor RH not pressed
    -

    OK:
    The power back door touch sensor functions as specified in the normal condition.



NG
GO TO OTHER FLOW CHART (TOUCH SENSOR CIRCUIT) (Click here)
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)