1.INSPECT TIRE AND INFLATION PRESSURE (Except North America)
Check the tires for wear and proper inflation pressure (See page Suspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).
2.TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
Where necessary, tighten all the parts of the chassis.
Front axle and suspension
Drivetrain
Rear axle and suspension
Brake system
Engine mounting, etc.
Where necessary, tighten all the parts of the body.
Seat belt system
Seat
Doors and hood
Body mountings
Fuel tank
Exhaust pipe system, etc.
3.INSPECT LIGHTS, HORN, WIPERS AND WASHERS (Except North America)
4.INSPECT REFRIGERANT AMOUNT FOR AIR CONDITIONER (Except North America)
Check the refrigerant pressure (See page Vehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>ON-VEHICLE INSPECTION).
5.CLEAN OR REPLACE AIR CONDITIONING FILTER
Remove the air conditioning filter (air refiner element) (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
If the clean air filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
Some filters are not able to be cleaned.
Some filters are not able to be cleaned.
6. FINAL INSPECTION
Check the operation of the body parts.
Hood
Auxiliary catch operates properly.
Hood locks securely when closed.
Front and rear doors
Door locks operate properly.
Doors close properly.
Back door
Door lock operates properly.
Door closes properly.
Seats
Seat adjusts easily and locks securely in any position.
Front seatback locks securely in any position.
Folding-down rear seatbacks lock securely.
Be sure to deliver a clean vehicle. Especially check:
Steering wheel
Shift lever knob
All switch knobs
Door handles
Seats