89438A
1.INSTALL POWER STEERING OIL PRESSURE SWITCH
Install a new O-ring to the oil pressure switch.
Apply a light coat of engine oil to the O-ring of the oil pressure switch.
When reusing the oil pressure switch, inspect the O-ring.
If the O-ring has scratches or cuts, replace the new O-ring.
Using a 24 mm deep socket wrench, install the oil pressure switch.
Connect the oil pressure switch connector.
2.ADD POWER STEERING FLUID
3.BLEED POWER STEERING FLUID
4.INSPECT FOR POWER STEERING FLUID LEAK
53736
5.INSTALL FRONT FENDER APRON SEAL RH