1.REMOVE EXHAUST MANIFOLD
Remove the exhaust manifold (See page Engine / Hybrid System>3UR-FE INTAKE / EXHAUST>EXHAUST MANIFOLD>REMOVAL).
2.REMOVE CAMSHAFT
Remove the camshaft (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>CAMSHAFT>REMOVAL).
13801
3.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
Remove the 32 valve rocker arms from the cylinder head.
Arrange the removed parts in the correct order.
13750
4.REMOVE VALVE LASH ADJUSTER ASSEMBLY
Remove the 32 valve lash adjusters from the cylinder head.
Arrange the removed parts in the correct order.
13716
5.REMOVE VALVE STEM CAP
Remove the 32 valve stem caps from the cylinder head.
Arrange the removed parts in the correct order.
11102
6.REMOVE CYLINDER HEAD LH
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an incorrect order.
Be sure to arrange the removed parts for each installation position separately.
11116
7.REMOVE NO. 2 CYLINDER HEAD GASKET
11101
8.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an incorrect order.
Be sure to arrange the removed parts for each installation position separately.
11115
9.REMOVE CYLINDER HEAD GASKET