1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISCHARGE FUEL SYSTEM PRESSURE
11209
3.REMOVE V-BANK COVER
17880
4.REMOVE AIR CLEANER HOSE ASSEMBLY
23902
5.REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY
23280
6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Disconnect the vacuum sensing hose from the fuel pressure regulator.
Remove the 2 bolts, and pull out the fuel pressure regulator.
Remove the O-ring from the pressure regulator.