1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
53736
4.REMOVE FRONT FENDER APRON SEAL RH
11452
5.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the dipstick.
Disconnect the wire harness clamp.
Remove the bolt and dipstick guide.
Remove the O-ring from the dipstick guide.
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58155
7.REMOVE FRONT NO. 3 FLOOR HEAT INSULATOR
17167
8.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
17104
9.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
28192
10.REMOVE STARTER COVER
Remove the 3 bolts and starter cover.
28100
11.REMOVE STARTER ASSEMBLY
Detach the 2 wire harness clamps.
Disconnect the starter connector.
Remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter.
Remove the flywheel housing side cover.