Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235639 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The ECM detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.

·

The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the CRUISE main indicator light by performing the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise CRUISE main indicator light Indicator light BLINK/OFF -

OK:

The indicator light blinks/goes off.




OK

2.READ VALUE USING TECHSTREAM

NG

REPLACE COMBINATION METER ASSEMBLY

2.READ VALUE USING TECHSTREAM
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Powertrain / Cruise Control / Data List.


e.

Check the Data List for proper functioning of the CRUISE main indicator light.

ECM (Cruise Control)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Indicator M-CPU Cruise indicator signal (Main CPU) / ON or OFF ON: "CRUISE" on
OFF: "CRUISE" off
-

OK:

When the cruise control main switch is operated, the display changes as shown above.


Result
Result Proceed to
NG A
OK (for 3UR-FE) B
OK (for 3UR-FBE) C



A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

B

C