Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Malfunction  P0503  Vehicle Speed Sensor Circuit Malfunction  


DESCRIPTION

The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system. The speed signal is converted for use by the cruise control inside the ECM.

Both the SFI system and the cruise control system can set DTC P0500, but the detection conditions of the two systems are different.

DTC No. DTC Detection Condition Trouble Area
P0500 The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while the cruise control is in operation.
·

Vehicle speed sensor

·

Vehicle speed sensor circuit

·

ECM

·

Combination meter assembly


P0503 Momentary interruption and noise malfunction codes are detected when a rapid change of vehicle speed occurs while the cruise control is in operation.

WIRING DIAGRAM

·

Refer to the SFI system (for 3UR-FE) (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>P0500).

·

Refer to the SFI system (for 3UR-FBE) (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>P0500).


CAUTION / NOTICE / HINT

·

Refer to the SFI system (for 3UR-FE) (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>P0500).

·

Refer to the SFI system (for 3UR-FBE) (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>P0500).


PROCEDURE

1.CHECK FOR DTC
a.

Check for DTC (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC P0500 and P0503 are not output A
DTC P0500 or P0503 is output (for 3UR-FE) B
DTC P0500 or P0503 is output (for 3UR-FBE) C



A

B

C