Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM D

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  INITIALIZATION  


INITIALIZE DISTANCE CONTROL ECU


NOTICE:

After replacing the distance control ECU and engine ECM, it is necessary to initialize the distance control ECU so that the ECU can recognize the specification of the vehicle.


a.

Perform the following procedures after replacing the distance control ECU.

i.

Turn the ignition switch to ON.


ii.

Turn the cruise main switch on.


iii.

With the brake pedal depressed, push the cruise control main switch to RES/ACC 3 times within 3 seconds. Check that the buzzer sounds at this time.

NOTICE:

Do not turn the headlight dimmer switch on at this time because the optical axis automatic adjustment mode has already started, which may lead to an incorrect optical axis setting. If the headlight dimmer switch is turned on by mistake, readjust the optical axis (See page Engine / Hybrid System>CRUISE CONTROL>LASER SENSOR>ADJUSTMENT).