Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  Washer Signal Circuit  


DESCRIPTION

The distance control ECU detects washer operation. The cruise control will be cancelled by the distance control ECU if the windshield wipers operate in the HI or LO mode. By detecting washer operation, the distance control ECU allows the cruise control to continue even when the windshield wipers operate in the HI or LO mode.

WIRING DIAGRAM

U154123E01
0.351,1.715 0.647,1.855 0.296,0.140 10 H14 0.351,1.923 2.112,2.089 1.761,0.166 10 Windshield Wiper Switch 1.293,1.05 1.540,1.216 0.248,0.166 10 WF 1.658,0.95 1.909,1.097 0.251,0.147 10 3 3.419,0.537 5.066,0.682 1.647,0.145 10 To Front Washer Motor 5.484,1.692 5.780,1.851 0.296,0.159 10 A43 5.489,1.863 6.884,2.039 1.395,0.175 10 Distance Control ECU 5.732,1.042 6.258,1.209 0.526,0.168 10 WASH 5.513,0.962 5.641,1.125 0.128,0.164 10 3

PROCEDURE

1.CHECK WASHER SYSTEM
a.

Check that the front washer operates.

OK:

Washer function is normal.




OK

2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH)

NG

2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH)
a.
U154125E02
2.573,1.198 2.448,1.198 2.448,1.198 1.385,1.583 false 2.469,3.229 2.344,3.229 2.344,3.229 2,3.635 false 0.292,0.125 2.615,0.448 2.323,0.323 10 false Front view of wire harness connector: (to Distance Control ECU) 0.365,2.094 2.688,2.427 2.323,0.333 10 false Front view of wire harness connector: (to Windshield Wiper Switch) 0.344,1.531 0.646,1.677 0.302,0.146 10 false A43 0.635,3.74 0.927,3.885 0.292,0.146 10 false H14 2.635,1.125 3.094,1.271 0.458,0.146 10 false WASH 2.531,3.156 2.781,3.313 0.25,0.156 10 false WF

Disconnect the A43 distance control ECU connector and H14 windshield wiper switch connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A43-3 (WASH) - H14-3 (WF) Always Below 1 Ω
H14-3 (WF) - Body ground Always 10 kΩ or higher



c.

Reconnect the distance control ECU connector and windshield wiper switch connector.



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR