Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM T

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Dynamic Laser Cruise Control System
Symptom Suspected Area See page
Main switch cannot be turned on. (CRUISE main indicator light on combination meter does not illuminate.) Cruise control switch circuit (Click here)
CRUISE main indicator light circuit (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Vehicle speed setting cannot be done. (CRUISE main indicator light on combination meter illuminates when main switch is turned on, but turns off when operating SET function.) Cruise control switch circuit (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Vehicle speed setting cannot be done. (CRUISE main indicator light on combination meter illuminates when main switch is turned on, and remains on when operating SET function.) Cruise control switch circuit (Click here)
Stop light switch circuit (Click here)
Transmission range sensor circuit (for AB60F) (Click here)
Transmission range sensor circuit (for AB60E) (Click here)
Vehicle speed sensor circuit (Click here)
Combination meter system (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
While vehicle is driven with cruise control, the control is canceled. (CRUISE main indicator light remains on.) Cruise control switch circuit (Click here)
Vehicle speed sensor circuit (Click here)
Stop light switch circuit (Click here)
Combination meter system (Click here)
Transmission range sensor circuit (for AB60F) (Click here)
Transmission range sensor circuit (for AB60E) (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Hunting (Speed is not constant.) Vehicle speed sensor circuit (Click here)
Malfunction in speed meter circuit (Click here)
Laser radar sensor power source circuit (Click here)
Distance control ECU power source circuit (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Vehicle speed setting cannot be canceled. (When coast, acceleration, resume, or set speed change function is operated with control switch.) Cruise control switch circuit (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Erroneous detection or lost sight of the vehicle ahead. Clean laser radar sensor with soft cloth, etc. -
Improper aiming of sensor beam axis (Click here)
Alarm buzzer does not sound. Skid control buzzer circuit (Click here)
VSC system (Click here)
Distance control ECU power source circuit (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Set distance cannot be changed. Combination meter system (Click here)
Distance control switch circuit (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
No information on the display Combination meter system (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
No brake control (when decelerating) VSC system (Click here)
Distance control ECU power source circuit (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Constant speed mode cannot be turned on. Cruise control switch circuit (Click here)
Combination meter system (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Vehicle speed setting cannot be canceled with wiper HI or LO. Wiper signal circuit (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Vehicle speed setting is canceled with washer ON. Washer signal circuit (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Unable to adjust (complete) beam axis of laser radar sensor. Check position, distance and angle of reflector -
Check installation of laser radar sensor (Click here)
Laser radar sensor (Click here)
Distance control ECU (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)
Cannot change from constant speed control mode to vehicle-to-vehicle distance control mode. Cruise control switch circuit (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FE). (Click here)
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM (for 3UR-FBE). (Click here)