Home › Drivetrain › AB60F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE
RM27L0U _52 Drivetrain _049310 AB60F AUTOMATIC TRANSMISSION / TRANSAXLE _0235647 TRANSMISSION WIRE A

AB60F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  REMOVAL  


PROCEDURE

Hide 35106 2.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

a.
C353371

Remove the 12 bolts, oil pan and gasket from the transmission.

NOTICE:

Some fluid will remain in the oil pan. Remove all the bolts, and carefully remove the oil pan assembly.



b.
AT00103

Examine the particles in the pan.

i.

Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

Steel (magnetic): bearing, gear and clutch plate wear

Brass (non-magnetic): bush wear



Hide 35330 3.REMOVE VALVE BODY OIL STRAINER ASSEMBLY

a.
C178807

Remove the 4 bolts and oil strainer.

NOTICE:

Be careful as some fluid may leak out of the oil strainer.



b.

Remove the O-ring from the oil strainer.


Hide 82125J 4.DISCONNECT TRANSMISSION WIRE

a.
U152298

Remove the 2 bolts and 2 temperature sensor clamps.


b.

Disconnect the 2 ATF temperature sensors.


c.

Disconnect the 9 connectors from the solenoid valves.


Hide 82125J 5.REMOVE TRANSMISSION WIRE

a.
U152294

Disconnect the 2 wire connectors.

HINT:

Detach the claw, press down the lever, and then disconnect the transmission wire connector.



b.
C161102

Remove the 2 bolts and pull out the 2 transmission wires.