Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM27L0U _52 Drivetrain _049314 AXLE AND DIFFERENTIAL _0235694 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43502C 1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for 2WD)

a.

Apply MP grease to a new O-ring.


b.

Install the O-ring to the axle hub.

NOTICE:

Do not damage the O-ring.



c.
C159319

Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque:
99 N*m (1010 kgf*cm, 73 ft.*lbf)


Hide 43502C 2.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for 4WD)

a.

Apply MP grease to a new O-ring.


b.

Install the O-ring to the axle hub.

NOTICE:

Do not damage the O-ring.



c.

Connect the front drive shaft to the front axle hub.

NOTICE:

Be careful not to damage the front drive shaft boot.



d.
C159319

Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque:
99 N*m (1010 kgf*cm, 73 ft.*lbf)


Hide 43502H 3.INSTALL FRONT AXLE HUB NUT LH (for 4WD)

a.

Clean the threaded parts on the drive shaft and axle hub nut using a non-residue solvent.

NOTICE:
·

Be sure to perform this work for a new drive shaft.

·

Keep the threaded parts free of oil and foreign objects.




b.

Using a 39 mm socket wrench, install the hub nut.

Torque:
338 N*m (3446 kgf*cm, 249 ft.*lbf)


c.
C159318

Install the front wheel adjusting lock cap and a new cotter pin.


Hide 4.INSPECT FRONT AXLE HUB

Hide 43514C 5.INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD)

a.

Install the axle hub grease cap.

NOTICE:

Make sure to securely fit the bearing to the axle hub.



Hide 43512 6.INSTALL FRONT DISC LH

Hide 7.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

a.
C159313

Connect the front disc brake caliper and install 2 new bolts.

Torque:
180 N*m (1835 kgf*cm, 133 ft.*lbf)

NOTICE:
·

Do not twist the flexible hose.

·

Make sure that the bolts are free from damage and foreign matter.

·

Do not overtighten the bolts.




b.
C159312

Connect the brake tube bracket to the steering knuckle with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 8.INSTALL FRONT WHEEL

·

for Aluminum Wheel


Torque:
131 N*m (1336 kgf*cm, 97 ft.*lbf)

·

for steel Wheel


Torque:
209 N*m (2131 kgf*cm, 154 ft.*lbf)

Hide 9.CHECK SPEED SENSOR SIGNAL