Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE CARRIER
RM27L0U _52 Drivetrain _049314 AXLE AND DIFFERENTIAL _0235696 REAR AXLE CARRIER A

AXLE AND DIFFERENTIAL  REAR AXLE CARRIER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48231B 1.REMOVE REAR COIL SPRING LH (for Rear Coil Spring Type)

Hide 48090B 2.REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH (for Pneumatic Cylinder Type)

Hide 3.REMOVE PARKING BRAKE ASSEMBLY

Hide 89546 4.REMOVE REAR SPEED SENSOR LH

a.
C178153

Disconnect the rear speed sensor connector.


b.

Using a hexagon wrench, remove the bolt and the rear speed sensor.


Hide 42418C 5.REMOVE REAR HUB GREASE CAP LH

a.
C180977

Using a screwdriver and hammer, remove the axle hub grease cap.

NOTICE:

Do not damage the axle hub.



Hide 42312B 6.REMOVE REAR AXLE SHAFT NUT LH

a.
C180976

Remove the cotter pin and adjusting lock cap.


b.

Using a 39 mm socket wrench, remove the axle hub nut.


Hide 48740F 7.SEPARATE NO. 2 REAR SUSPENSION ARM ASSEMBLY LH

a.
C180775

Remove the cotter pin and nut.


b.

Using SST, separate the No. 2 rear suspension arm.

SST
09950-40011  (09951-04010, 09953-04020, 09954-04010, 09955-04031, 09958-04011, 09952-04010)
09955-04090  

HINT:
·

Claw A 09955-04090

·

Claw B 09955-04031



C353495E01
2.76,1.719 3.031,1.719 false 4.719,0.854 4.99,0.854 false 5.781,1.354 6,1.552 6,1.552 6.146,1.552 false 3.094,1.646 3.552,1.844 0.458,0.198 10 false SST 4.26,0.76 4.76,0.938 0.5,0.177 10 false Claw A 6.188,1.469 6.646,1.667 0.458,0.198 10 false Claw B


Hide 8.REMOVE REAR AXLE ASSEMBLY

a.
C180987E02
0.76,2.656 1.594,2.948 1.594,2.948 2.479,2.531 false 1.167,2.948 1.958,3.104 0.792,0.156 10 false Matchmarks

Put matchmarks on the No. 1 rear suspension arm and adjust cam.


b.

Remove the 2 bolts and nut.


c.

Using a plastic-faced hammer, tap out the front drive shaft from the rear axle carrier sub-assembly LH.

NOTICE:

Be careful not to damage the drive shaft boot.



Hide 42305 9.REMOVE REAR AXLE CARRIER LH

a.
C180966

Remove the 4 bolts and axle hub and bearing from the rear axle carrier.


b.
C180968

Remove the O-ring from rear axle hub.


Hide 42402J 10.REMOVE REAR AXLE HUB DUST SEAL LH

a.
C180969

Using a screwdriver and hammer, remove the bearing dust deflector from the rear axle carrier.