Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235712 AIR SUSPENSION SYSTEM D

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  DIAGNOSIS SYSTEM  


CHECK DLC3


a.

Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).

HINT:
·

If any properly connected ECUs or sensors are not displayed, there is a communication stop in the system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>PROBLEM SYMPTOMS TABLE).

·

Display the communication BUS check screen for approximately 1 minute and check for ECUs and sensors that are not indicated on the screen.





DTCs (Normal mode)


a.

DTCs are memorized in the suspension control ECU and read by using the Techstream (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>TEST MODE PROCEDURE).



TEST MODE


a.

By switching from normal mode into test mode, you can inspect the height control switch, height control mode select switch, and absorber control switch (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>TEST MODE PROCEDURE).



CHECK INDICATOR LIGHT


a.

Turn the ignition switch to ON.


b.

Check that the height control MAN. indicator light and the height control indicator light come on for 2 seconds. If the indicator check result is not normal, proceed to troubleshooting for the CAN Communication System (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).