Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
RM27L0U _57 Power Source / Network _049335 NETWORKING _0235802 CAN COMMUNICATION SYSTEM T

NETWORKING  CAN COMMUNICATION SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Result of CAN V1 Bus Check
Symptom Suspected Area See page
Open in CAN Main Wire CAN Main Bus Line (Click here)
Short in CAN Bus Lines CAN Bus Line (Click here)
Short to +B in CAN Bus Line CAN Bus Line (Click here)
Short to GND in CAN Bus Line CAN Bus Line (Click here)
Open in One Side of CAN Branch Line CAN Branch Line (Click here)

HINT:

Refer to How to Proceed with Troubleshooting for the CAN V1 bus check procedure.


Communication Stop Mode Table
Symptom Suspected Area See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on the Techstream Skid Control ECU Communication Stop Mode (Click here)
"Air Conditioning Amplifier" is not displayed on the Techstream Air Conditioning Amplifier Communication Stop Mode (Click here)
"Power Steering (EPS)" is not displayed on the Techstream Power steering ECU Communication Stop Mode (Click here)
"CAN Gateway1" is not displayed on the Techstream (w/ Network Gateway ECU) Gateway ECU Communication Stop Mode (Click here)
"Spiral cable (Steering Angle Sensor)" is not displayed on the Techstream Steering Angle Sensor Communication Stop Mode (Click here)
"ECM (Engine)" is not displayed on the Techstream ECM Communication Stop Mode (Click here)
"Main Body" is not displayed on the Techstream Main Body ECU Communication Stop Mode (Click here)
"Combination Meter" is not displayed on the Techstream Combination Meter ECU Communication Stop Mode (Click here)
"Airbag" is not displayed on the Techstream Center Airbag Sensor Communication Stop Mode (Click here)
"Suspension Control (Air Suspension)" is not displayed on the Techstream (w/ Air Suspension System) Suspension Control ECU Communication Stop Mode (Click here)
"Four Wheel Drive Control" is not displayed on the Techstream (for 4WD) 4WD Control ECU Communication Stop Mode (Click here)
"Accessory Gateway" is not displayed on the Techstream (w/ Bus Buffer ECU) Bus Buffer ECU Communication Stop Mode (Click here)