Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235712 AIR SUSPENSION SYSTEM C

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  C1781  Suspension Control ECU Malfunction  


DESCRIPTION

If a malfunction in the suspension control ECU is detected, DTC C1781 is output.

DTC Code Detection Condition Trouble Area
C1781 Suspension control ECU malfunction is detected. Suspension control ECU

CAUTION / NOTICE / HINT

NOTICE:

After replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).


HINT:
·

If DTC C1782 (ECU malfunction) is displayed, perform the inspection necessary for DTC C1782 first (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>C1782).

·

If DTC U0122, U0100, U0124, U0126, U0140 and C1781 (Suspension Control ECU Malfunction) are output at the same time, perform the inspection necessary for the CAN communication system first.

·

The suspension control ECU, controlling the air suspension system, is activated when the ignition switch is turned to ON.

After 2 seconds, the "MAIN RELAY" built into the ECU is activated and the system is driven by +B power source.

Vehicle height may increase after turning the ignition switch off and unloading the vehicle/letting people get out of the vehicle. In order to adjust the vehicle height, vehicle height control will continue for a while from then.



PROCEDURE

1.CHECK FOR DTC

b.

Perform a road test.


c.

Check for DTC (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

REPLACE SUSPENSION CONTROL ECU

B