Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM27L0U _53 Suspension _049318 REAR SUSPENSION _0235723 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  INSTALLATION  


PROCEDURE

Hide 48231B 1.INSTALL REAR COIL SPRING LH

a.

Using SST, compress the coil spring.

SST
09727-30021  


b.

Fit the coil spring to the No. 2 lower arm, and jack up the No. 2 lower arm. Install the coil spring as shown in the illustration.

C206454E02
2.719,1.281 2.552,1.281 false 2.552,1.281 1.833,1.521 true 5.969,2.354 5.698,2.354 false 5.698,2.354 5.542,2.094 true 6.219,0.406 5.969,0.406 false 5.969,0.406 5.74,0.823 false 1.469,0.417 1.552,0.417 false 1.552,0.417 1.656,0.823 false 0.302,0.052 1.208,0.396 0.906,0.344 12 false for LH side: 3.74,0.052 4.76,0.292 1.021,0.24 12 false for RH side: 1.896,0.24 2.229,0.458 0.333,0.219 10 false 24° 4.354,1.26 4.688,1.479 0.333,0.219 10 true 150° 2.76,1.198 3.948,1.458 1.188,0.26 10 false Coil Spring End 6,2.281 7.063,2.583 1.063,0.302 10 false Coil Spring End 6.25,0.323 6.542,0.51 0.292,0.188 10 false Tab 1.219,0.333 1.51,0.521 0.292,0.188 10 false Tab


c.
C181307E02
2.292,0.333 2.167,0.333 2.167,0.333 1.792,1.177 true 2.333,0.26 2.927,0.563 0.594,0.302 10 true ID Mark

Confirm that the ID mark on the rear coil spring is visible through the drain hole of the No. 2 lower arm.

NOTICE:

If the ID mark is not visible, reinstall the coil spring.



d.

Remove the SST from the coil spring.


Hide 48790 2.TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

Hide 48540 3.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

Hide 4.INSPECT AND ADJUST REAR WHEEL ALIGNMENT