Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM27L0U _53 Suspension _049318 REAR SUSPENSION _0235722 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


PROCEDURE

Hide 48540 1.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY (w/o Air Suspension)

a.

Temporarily install the upper side of the shock absorber to the chassis frame with the bolt and nut.


b.

Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt.


Hide 48540 2.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY (w/ Air Suspension)

a.

Temporarily install the upper side of the shock absorber to the chassis frame with the bolt and nut.


b.

Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt.


c.

Connect the AVS connector.


Hide 48812 3.INSTALL REAR STABILIZER BAR

Hide 89408D 4.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Air Suspension)

Hide 37110 5.INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD)

Hide 37117B 8.INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD)

Hide 17430 9.INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FE)

Hide 17430 10.INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FBE)

Hide 11.INSTALL REAR WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)

Hide 12.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several times to stabilize the suspension.


Hide 48540 13.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

C180767E01
0.182,0.084 0.323,0.244 0.141,0.160 10 A 0.981,1.864 1.119,2.038 0.138,0.174 10 B

a.

Tighten the 2 bolts and nut.

Torque:
for Bolt and Nut A : 135 N*m (1377 kgf*cm, 100 ft.*lbf)
for Bolt B : 90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 14.INSPECT AND ADJUST REAR WHEEL ALIGNMENT