CHECK BATTERY VOLTAGE
11 to 14 V
If the voltage is below 11 V, recharge the battery before proceeding.
DIAGNOSIS SYSTEM
Warning light
When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5-second intervals, and turns on after 1 minute.
DTCs (Normal mode)
DTCs are memorized in the tire pressure warning ECU and read by the blinks of the tire pressure warning light or by using the Techstream (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).
Test mode
By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning antenna and receiver, each tire pressure warning valve and transmitter, and vehicle speed sensor (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>TEST MODE PROCEDURE).
CHECK TIRE PRESSURE WARNING LIGHT
Turn the ignition switch to ON.
TIRE PRESSURE WARNING LIGHT CHART
The table below indicates the state of the tire pressure warning light after the ignition switch is turned to ON.
| Condition | Immediately after Turning Ignition Switch ON | Always | ||||||
|---|---|---|---|---|---|---|---|---|
| Warning Light Output Pattern | ||||||||
| Turns on for 3 Seconds | Goes Off | Turns On | Blinks for 1 Minute and then Illuminates*1 | Blinks*2 | Blinks*3 | Blinks*4 | Output DTC | |
| Normal | ○ | ○ | - | - | - | - | - | - |
| Low tire pressure | ○ | - | ○ | - | - | - | - | - |
| System failure | ○ | - | - | ○ | - | - | - | - |
| Test mode | ○ | - | - | - | ○ | - | - | - |
| Initialization | ○ | - | - | - | - | ○ | - | - |
| ECU connector poorly connected | - | - | - | ○*5 | - | - | - | - |
| TC ground (DTC is output) | ○ | - | - | - | - | - | - | ○ |
| TC ground (DTC is not output) | ○ | - | - | - | - | - | ○ | - |
*1: Turns on and goes off repeatedly at 0.5-second intervals, and turns on after 1 minute.
*2: Turns on and goes off repeatedly at 0.125-second intervals.
*3: Blinks 3 times (1 second on, 1 second off).
*4: Turns on and goes off repeatedly at 0.25-second intervals.
*5: When there is a open circuit, the light is off for 10 seconds. Then it blinks at 0.5-second intervals, and turns on after 1 minute.