Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM27L0U _54 Brake _049321 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0235735 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  U0073/94  Control Module Communication Bus OFF  U0100/65  Lost Communication with ECM / PCM  U0114/27  Lost Communication with 4-Wheel Drive Clutch Control Module  U0123/62  Lost Communication with Yaw Rate Sensor Module  U0124/69  Deceleration Sensor Communication Circuit Malfunction  U0126/63  Lost Communication with Steering Angle Sensor Module  


DESCRIPTION

The skid control ECU exchanges signals with the ECM, steering angle sensor, yaw rate and deceleration sensor, power steering ECU, main body ECU and combination meter via CAN communication.

DTC Code DTC Detection Condition Trouble Area
U0073/94 Bus off conditions continue for approximately 0.8 seconds. CAN communication system
U0100/65 When CAN signal from ECM is lost or malfunctioning for 1.2 seconds.
·

CAN communication system

·

ECM


U0114/27 When CAN signal from 4WD control ECU is lost or malfunctioning for 1.2 seconds.
·

CAN communication system

·

4WD control ECU


U0123/62 Supplied voltage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds.
·

CAN communication system

·

Yaw rate sensor


U0124/69 Supplied voltage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds.
·

CAN communication system

·

Yaw rate sensor


U0126/63 Supplied voltage normal (9.7 V or more), skid control ECU receives no steering angle sensor data for 0.1 seconds.
·

CAN communication system

·

Steering angle sensor



PROCEDURE

1.RECONFIRM DTC

b.

Check if the same DTC(s) is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

B