The stop light control relays are built into the stop light circuit and prohibits the stop light from turning on under VSC control.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1311/12 | Open or short circuit is detected. | ·
Stop light control relay ·
Stop light control circuit ·
VSC actuator (skid control ECU) |
| C1380/64 |
Refer to DTC C1249/49 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1249/49).
When replacing the VSC actuator assembly, perform the zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Remove the stop light control relays from the engine room relay block.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Stop light control relay terminal 1 (BRK NO. 1) - Body ground | Ignition switch ON | 11 to 14 V |
| Stop light control relay terminal 1 (BRK NO. 2) - Body ground |
OK
NG
Remove the stop light control relays (BRK NO. 1 and BRK NO. 2) from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | When battery voltage is not applied to terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | When battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 4 | When battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | When battery voltage is not applied to terminals 1 and 2 | Below 1 Ω |
| When battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
OK
NG
Disconnect the A19 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A19-44 (BSW) - Body ground | Ignition switch ON | 11 to 14 V |
| A19-15 (STPO) - Body ground | Ignition switch ON | 11 to 14 V |
OK
NG