1.REMOVE PRECAUTION
After turning the ignition switch off, waiting time be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67914B
3.REMOVE FRONT DOOR SCUFF PLATE LH
62112
4.REMOVE COWL SIDE TRIM BOARD LH
55318C
5.REMOVE INSTRUMENT SIDE PANEL LH
53601
6.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55046A
7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
73900
8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY
55971C
9.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
Remove the bolt and defroster nozzle duct.
47264A
10.REMOVE PUSH ROD PIN
Remove the clip and push rod pin from the brake pedal lever.
84340
11.REMOVE STOP LIGHT SWITCH ASSEMBLY
84340
12.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
Remove the stop light switch mounting adjuster.
55106
13.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY
Remove the brake pedal return spring.
Remove the bolt from the No. 3 brake pedal bracket.
Remove the bolt, nut and No. 3 brake pedal bracket from the brake pedal support.
Remove the 4 nuts and brake pedal support.
47121
14.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad.