Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
47201
4.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
Remove the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>REMOVAL).
44773F
5.DISCONNECT VACUUM HOSE ASSEMBLY
Slide the clip and disconnect the vacuum hose from the check valve.
6.DISCONNECT BRAKE BOOSTER CONNECTOR
Disconnect the 2 brake booster connectors from the brake booster.
67914
7.REMOVE FRONT DOOR SCUFF PLATE LH
62112
8.REMOVE COWL SIDE TRIM BOARD LH
55318C
9.REMOVE INSTRUMENT SIDE PANEL LH
53601
10.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55046A
11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
73900
12.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY
47264A
13.REMOVE PUSH ROD PIN
Remove the clip and push rod pin.
44610
14.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts, and then pull out the brake booster.
Remove the brake booster gasket from the brake booster.
Loosen the lock nut and then remove the clevis.
44730
15.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY