CHECK DTC
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / PPS / Trouble Codes.
Read the DTCs following the display on the Techstream.
Refer to Diagnostic Trouble Code Chart for DTC information (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / PPS / Trouble Codes.
Clear the DTCs by following the display on the Techstream.
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.