Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM27L0U_55Steering_049326POWER ASSIST SYSTEMS_0235759POWER STEERING SYSTEMS
POWER ASSIST SYSTEMS POWER STEERING SYSTEM DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
Power Steering System
DTC Code
Detection Item
Trouble Area
Return to normal
See page
C1231
Lost Communication with Steering Angle Sensor Module
- Steering angle sensor
- CAN communication system
- Power steering ECU assembly
After normal condition
()
C1531
ECU Malfunction
- Harness or connector
- Vane pump assembly (Power steering solenoid valve)
- Power steering ECU assembly
Ignition switch turned to ON again
()
C1544
High Engine Revolution Signal
- SFI system
- CAN communication system
- Power steering ECU assembly
After normal condition
()
C1547
Vehicle Speed Sensor
- Speed sensor circuit
- Brake control system
- CAN communication system
- Power steering ECU assembly
After normal condition
()
U0073
Control Module Communication Bus Off
- CAN communication system
After CAN communication system returns to normal condition or ignition switch turned to ON again