Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
RM27L0U _55 Steering _049327 STEERING COLUMN _0235762 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2624  Vehicles Speed Malfunction  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that they are connected to the network by outputting a specified signal (periodic signal) to the communication bus at regular intervals. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code Detection Condition Trouble Area
B2624 When either condition below is met:
·

The auto away function is disabled with the last vehicle speed signal* of 10 km/h (6 mph) or more.

·

Vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.


·

CAN communication system

·

Combination meter

·

Multiplex tilt and telescopic ECU



HINT:

*: If the ignition switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check the DTC of the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)

B

2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)
a.

Use the Data List to check if the speed signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Freez Speed Info Vehicle speed data / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Actual vehicle speed -


Result
Result Proceed to
OK or NG (Tester indication is abnormal) A
NG (Meter indication is abnormal) B

HINT:

Vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.



A

B