Home › Steering › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column)
RM27L0U _55 Steering _049327 STEERING COLUMN _0235765 MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

Some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

a.
C290043

Remove the 2 screws.

HINT:

Turn the steering wheel to the right and left as necessary to remove the 2 screws.



b.
C290044

Detach the 4 clips.


c.

Detach the claw to remove the upper steering column cover.


Hide 45287 4.REMOVE LOWER STEERING COLUMN COVER

a.
C290045

Detach the 2 claws to remove the lower steering column cover.


Hide 53601 5.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55046A 6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 89227 9.REMOVE MULTIPLEX TILT AND TELESCOPIC ECU

a.
C162089

Disconnect the 2 ECU connectors.


b.

Remove the 2 screws and ECU.