Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049329 AUDIO / VIDEO _0235782 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio and display receiver assembly and steering pad switch assembly illumination when the headlight dimmer switch assembly is in the tail or head position.

WIRING DIAGRAM

E283618E02
6.135,0.5 6.49,0.667 0.354,0.167 10 false ILL+ 5.781,0.49 5.99,0.656 0.208,0.167 10 false I58 5.781,0.292 6.01,0.458 0.229,0.167 10 false 10 4.854,3.458 5.25,3.625 0.396,0.167 10 false H54 4.927,3.25 5.156,3.417 0.229,0.167 10 false 9 3.698,3.448 3.99,3.615 0.292,0.167 10 false z12 4.24,3.375 4.729,3.542 0.49,0.167 10 false EAC 3.969,4.031 4.865,4.688 0.896,0.656 10 false Spiral Cable Sub-assembly 3.771,3.25 4,3.417 0.229,0.167 10 false 2 4.844,1.104 5.24,1.271 0.396,0.167 10 false H54 4.885,0.906 5.115,1.073 0.229,0.167 10 false 12 3.677,1.104 3.969,1.271 0.292,0.167 10 false z12 4.229,1.01 4.719,1.177 0.49,0.167 10 false IL+2 0.26,0.49 1.563,0.781 1.302,0.292 10 false from PANEL Fuse 3.75,0.917 3.979,1.083 0.229,0.167 10 false 5 6.125,5 6.479,5.167 0.354,0.167 10 false ILL- 5.156,4.927 5.51,5.094 0.354,0.167 10 false 37 3.74,5.406 4.104,5.573 0.365,0.167 10 false H37 3.74,5.583 5.646,5.938 1.906,0.354 10 false Combination Meter Assembly 0.74,6.063 3.365,6.406 2.625,0.344 10 false Steering Pad Switch Assembly 0.833,5.583 2.833,5.875 2,0.292 10 false Steering Pad Switch RH Side 0.688,3.719 2.688,4.052 2,0.333 10 false Steering Pad Switch LH Side 1.063,4.542 1.615,4.708 0.552,0.167 10 false Voice 1.417,3.26 2.656,3.427 1.24,0.167 10 false MODE 0.906,5.063 2.573,5.229 1.667,0.167 10 false On/off hook 0.833,2.188 1.615,2.354 0.781,0.167 10 false Down/Left 1.719,2.177 2.313,2.344 0.594,0.167 10 false Volume- 0.885,1.688 1.677,1.906 0.792,0.219 10 false Up/Right 1.708,1.688 2.302,1.854 0.594,0.167 10 false Volume+ 4.792,5.01 5.146,5.177 0.354,0.167 10 false ILL- 5.781,5 5.99,5.167 0.208,0.167 10 false I59 5.833,4.74 5.958,4.906 0.125,0.167 10 false 5 5.833,6.135 7.094,6.76 1.26,0.625 10 false Radio and Display Receiver Assembly

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio and display receiver assembly, steering pad switch assembly, glove box or other parts (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

Result
Result Proceed to
Illumination comes on for all components except steering pad switch assembly A
Illumination comes on for all components except radio and display receiver assembly B
No illumination comes on (radio and display receiver assembly, hazard switch, glove box, etc.) C
Illumination comes on for all components except steering pad switch assembly and radio and display receiver assembly D



A

2.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY)

B

4.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY)

C

D

5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY)
a.
U153925E01
2.504,1.762 2.830,1.909 0.326,0.147 10 IL+2 0.719,1.922 1.045,2.068 0.326,0.147 10 EAC 2.103,1.682 2.305,1.86 2.305,1.86 2.474,1.86 false 1.629,1.682 1.286,2.001 1.286,2.001 1.117,2.001 false 0.045,0.038 0.377,0.234 0.332,0.196 10 *a 0.659,1.404 0.957,1.585 0.297,0.181 10 H54

Disconnect the spiral cable sub-assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
H54-9 (EAC) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H54-12 (IL+2) - Body ground Headlight dimmer switch assembly tail or head 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Spiral Cable Sub-assembly)



OK

3.INSPECT STEERING PAD SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>INSTALLATION).



OK

REPLACE SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY)
a.
U154167E01
1.572,0.257 1.865,0.441 0.293,0.184 10 I58 0.053,0 0.347,0.184 0.293,0.184 10 *a 2.785,1.735 3.150,1.919 0.366,0.184 10 ILL+ 2.321,1.4 2.496,1.818 2.496,1.818 2.762,1.818 false

Disconnect the radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I58-10 (ILL+) - Body ground Headlight dimmer switch assembly tail or head 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the I59 radio and display receiver assembly connector.


b.

Disconnect the H37 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I59-5 (ILL-) - H37-37 (ILL-) Always Below 1 Ω
I59-5 (ILL-) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR