Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049330 NAVIGATION / MULTI INFO DISPLAY _0235785 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the navigation receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the navigation receiver assembly cannot be operated using the steering pad switch assembly, and also the navigation receiver assembly itself cannot function.

WIRING DIAGRAM

E283434E05
4.01,3.406 3.135,3.406 false 0.698,1.604 1.115,1.781 0.417,0.177 10 false VOL- 1.375,5.74 1.844,6.188 0.469,0.448 10 false OFF HOOK 0.573,5.813 1.104,6.052 0.531,0.24 10 false VOICE 1.073,7.313 3.115,7.594 2.042,0.281 10 false Steering Pad Switch Assembly 2.198,5.729 2.667,6.135 0.469,0.406 10 false ON HOOK 1.427,1.604 1.885,1.781 0.458,0.177 10 false VOL+ 4.969,0.958 5.26,1.135 0.292,0.177 10 false AU1 4.979,4.052 5.281,4.229 0.302,0.177 10 false AU2 4.969,2.063 5.271,2.24 0.302,0.177 10 false EAU 4.979,3.177 5.271,3.354 0.292,0.177 10 false AU3 6.302,1.031 6.677,1.208 0.375,0.177 10 false SW1 6.302,2.146 6.688,2.323 0.385,0.177 10 false SWG 6.302,4.135 6.677,4.313 0.375,0.177 10 false SW2 6.302,3.271 6.677,3.448 0.375,0.177 10 false SW3 5.74,5.104 6.198,5.281 0.458,0.177 10 false I53 2.031,1.604 2.594,1.781 0.563,0.177 10 false DOWN 4.573,1.042 4.854,1.219 0.281,0.177 10 false z12 4.594,2.156 4.896,2.333 0.302,0.177 10 false z12 4.583,3.26 4.885,3.438 0.302,0.177 10 false z12 4.604,0.854 4.781,1.031 0.177,0.177 10 false 10 4.646,1.958 4.74,2.135 0.094,0.177 10 false 8 4.594,4.146 4.896,4.323 0.302,0.177 10 false z12 4.646,3.958 4.74,4.135 0.094,0.177 10 false 9 4.646,3.052 4.74,3.229 0.094,0.177 10 false 7 5.417,1.031 5.708,1.208 0.292,0.177 10 false H54 5.438,4.156 5.729,4.333 0.292,0.177 10 false H54 5.438,2.146 5.729,2.323 0.292,0.177 10 false H54 5.427,3.26 5.771,3.438 0.344,0.177 10 false H54 6.063,0.969 6.24,1.146 0.177,0.177 10 false 21 6.063,2.063 6.24,2.24 0.177,0.177 10 false 23 6.052,4.063 6.229,4.24 0.177,0.177 10 false 22 6.063,3.177 6.24,3.354 0.177,0.177 10 false 24 5.51,1.958 5.604,2.135 0.094,0.177 10 false 4 5.531,3.927 5.625,4.104 0.094,0.177 10 false 5 5.5,0.844 5.594,1.021 0.094,0.177 10 false 6 5.51,3.083 5.604,3.26 0.094,0.177 10 false 3 0.677,2.708 1.385,2.885 0.708,0.177 10 false LEFT 1.396,2.698 2.104,2.875 0.708,0.177 10 false RIGHT 2.073,2.719 2.781,2.896 0.708,0.177 10 false BACK 2.667,2.698 3.375,2.875 0.708,0.177 10 false ENTER 4.708,5.385 5.719,5.813 1.01,0.427 10 false Spiral Cable Sub-assembly 5.74,5.26 7.021,5.708 1.281,0.448 10 false Navigation Receiver Assembly 2.854,1.604 3.406,1.781 0.552,0.177 10 false UP 0.844,6.708 2.76,6.979 1.917,0.271 10 false Steering Pad Switch RH Side 0.896,4.51 2.813,4.781 1.917,0.271 10 false Steering Pad Switch LH Side 2.656,3.76 3.365,3.938 0.708,0.177 10 false MODE

CAUTION / NOTICE / HINT

NOTICE:

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSPECTION).



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).


b.

Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- SPIRAL CABLE SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- SPIRAL CABLE SUB-ASSEMBLY)
a.

Disconnect the I53 navigation receiver assembly connector.


b.

Disconnect the H54 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance::
Tester Connection Condition Specified Condition
I53-21 (SW1) - H54-6 (AU1) Always Below 1 Ω
I53-22 (SW2) - H54-5 (AU2) Always Below 1 Ω
I53-24 (SW3) - H54-3 (AU3) Always Below 1 Ω
I53-23 (SWG) - H54-4 (EAU) Always Below 1 Ω
I53-21 (SW1) - Body ground Always 10 kΩ or higher
I53-22 (SW2) - Body ground Always 10 kΩ or higher
I53-24 (SW3) - Body ground Always 10 kΩ or higher
I53-23 (SWG) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR