The No. 2 ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.
Remove the No. 2 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>REMOVAL).
Inspect the No. 2 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>INSPECTION)
OK
NG
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>REMOVAL)
Disconnect the C1 No. 2 ultrasonic sensor (front corner sensor LH) connector.
Disconnect the B1 No. 2 ultrasonic sensor (front corner sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C1-1 (BI) - B1-2 (BO) | Always | Below 1 Ω |
| C1-3 (SI) - B1-4 (SO) | Always | Below 1 Ω |
| C1-5 (EI) - B1-6 (EO) | Always | Below 1 Ω |
| C1-1 (BI) or B1-2 (BO) - Body ground | Always | 10 kΩ or higher |
| C1-3 (SI) or B1-4 (SO) Body ground | Always | 10 kΩ or higher |
| C1-5 (EI) or B1-6 (EO) - Body ground | Always | 10 kΩ or higher |
OK
NG