Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM D

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on.


d.

Turn the Techstream on.


e.

Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.

HINT:

The blind spot monitor sensor RH and LH both store DTCs. Therefore, check the DTCs for both of the blind spot monitor sensors.





CLEAR DTC


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on.


d.

Turn the Techstream on.


e.

Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.


f.

Clear the DTCs.