This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.
When the blind spot monitor sensor is replaced, this DTC is stored, but it does not indicate a malfunction. After replacing the blind spot monitor sensor, enter test mode to force the blind spot monitor sensor to recognize that axis inspection is complete so that the sensor will stop inappropriately storing this DTC. After that, clear the DTCs.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1ABB | A beam axis inspection has not been performed. | Blind spot monitor sensor RH |
Perform beam axis inspection using the intelligent tester (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).
NEXT