88171
1.INSTALL BLIND SPOT MONITOR BRACKET LH
Install a new grommet to the body panel.
Attach the 2 claws to temporarily install the blind spot monitor bracket LH to the body panel.
| *a | Bolt |
Temporarily install the 2 bolts to the blind spot monitor bracket LH.
Tighten the 2 bolts, and then tighten the screw.
88161
2.INSTALL BLIND SPOT MONITOR BRACKET RH
Use the same procedure described for the LH side.
88172
3.INSTALL BLIND SPOT MONITOR SENSOR LH
Connect the connector.
Install the blind spot monitor sensor LH with the 3 nuts.
88162
4.INSTALL BLIND SPOT MONITOR SENSOR RH
Use the same procedure described for the LH side.
52159
5.INSTALL REAR BUMPER COVER