Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
RM27L0U _57 Power Source / Network _049335 NETWORKING _0235802 CAN COMMUNICATION SYSTEM C

NETWORKING  CAN COMMUNICATION SYSTEM  B2624  Vehicles Speed Malfunction  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code Detection Condition Trouble Area
B2624
·

The auto away function is disabled with the last vehicle speed signal* at 10 km/h (6 mph) or more.

·

Vehicle speed signal is lost for 10 seconds or more and the auto away/return function is disabled.


·

CAN communication system

·

Meter/gauge system

·

Multiplex tilt and telescopic ECU



HINT:

*: If the ignition switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


PROCEDURE

1.CHECK OTHER DTC OUTPUT
a.

Check if DTC B2621 is output (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
B2621 is not output A
B2621 is output B



A

2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)

B

REPAIR CIRCUIT INDICATED BY OUTPUT CODE

2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)
a.

Use the Data List to check if the speed signal is functioning properly.

Tilt and Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Freeze Speed Info Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Stop → Drive → Stop 0 km/h (0 mph) → Same speed as indicated on speedometer → 0 km/h (0 mph)


Result
Result Proceed to
Tester indication is normal A
Tester indication is abnormal B

HINT:

A vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.



A

B

GO TO METER/GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)