Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU
RM27L0U _57 Power Source / Network _049335 NETWORKING _0235804 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913B 3.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 62111C 4.REMOVE COWL SIDE TRIM BOARD RH

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55045A 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 89111 10.REMOVE NETWORK GATEWAY ECU

a.
B278084

Disconnect the network gateway ECU connector.


b.

Remove the 2 nuts and the network gateway ECU.