Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67673A
3.REMOVE REAR DOOR FRAME GARNISH
74271A
4.REMOVE REAR DOOR ARMREST BASE UPPER PANEL
69283A
5.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
67603
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67625D
7.REMOVE REAR DOOR TRIM NO. 2 BRACKET
67841E
8.REMOVE REAR DOOR SERVICE HOLE COVER
68152C
9.REMOVE REAR DOOR GLASS RUN
67407F
10.REMOVE REAR DOOR WINDOW FRAME REAR LOWER SUB-ASSEMBLY
68103
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69050A
12.REMOVE REAR DOOR LOCK
Using a "TORX" socket wrench T30, remove the 3 screws.
Move the rear door lock downward and pull the release plate out of the rear door outside handle frame.
Remove the door lock wire harness seal from the rear door lock.
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
Remove the rear door lock remote control cable.
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.
Remove the rear door inside locking cable.