Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER
RM27L0U _58 Vehicle Interior _049339 METER / GAUGE / DISPLAY _0235843 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


PROCEDURE

Hide 83100 1.INSTALL COMBINATION METER ASSEMBLY

a.

Connect the connector and attach the wire harness clamp.


b.

Install the combination meter assembly with the 4 screws.


Hide 55410C 2.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55046A 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)