In this circuit, the combination meter receives the engine coolant temperature signals from the ECM using the CAN communication lines. The combination meter displays an engine coolant temperature that is calculated based on the data received from the ECM.
Use the Techstream to check if the CAN communication system is functioning normally (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
B
Check for DTCs (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| SFI system DTC is not output | A |
| SFI system DTC (for 3UR-FE) is output | B |
| SFI system DTC (for 3UR-FBE) is output | C |
A
B
C