Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM27L0U _58 Vehicle Interior _049339 METER / GAUGE / DISPLAY _0235844 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Fuel Receiver Gauge Malfunction  


DESCRIPTION

The fuel sender gauge has a variable resistance mechanism. The resistance decreases when the fuel amount increases, and the resistance increases when the fuel amount decreases. The fuel receiver gauge changes based on the resistance of the fuel sender gauge.

WIRING DIAGRAM

B166182E03
4.444,2.997 4.722,3.186 0.278,0.188 10 H37 5.254,1.734 5.644,1.922 0.390,0.188 10 FUEL 4.185,0.704 4.398,0.893 0.213,0.188 10 12 4.185,1.25 4.398,1.438 0.213,0.188 10 39 2.604,1.25 2.772,1.438 0.168,0.188 10 2 3.476,1.25 3.644,1.438 0.168,0.188 10 3 4.456,0.704 4.822,0.893 0.366,0.188 10 L 4.456,1.25 4.822,1.438 0.366,0.188 10 E3 4.185,2.261 4.398,2.449 0.213,0.188 10 40 2.503,1.648 2.779,1.836 0.276,0.188 10 Q1 2.503,1.848 3.825,2.036 1.322,0.188 10 Fuel Sender Gauge 4.456,2.261 4.822,2.449 0.366,0.188 10 E1 4.444,3.179 5.723,3.367 1.279,0.188 10 Combination Meter

PROCEDURE

1.CHECK DTC
a.

Check the DTCs (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1500 is not output A
DTC B1500 is output B



A

2.PERFORM ACTIVE TEST USING TECHSTREAM (FUEL RECEIVER GAUGE)

B

2.PERFORM ACTIVE TEST USING TECHSTREAM (FUEL RECEIVER GAUGE)
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream ON.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the Techstream, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2 or FULL -

OK:

Needle indication is normal.




OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE COMBINATION METER ASSEMBLY