Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235855 OCCUPANT CLASSIFICATION ECU A

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION ECU  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1.INSTALL OCCUPANT CLASSIFICATION ECU (for Manual Seat)

a.
B194815

Check that the ignition switch is off.


b.

Check that the negative battery (-) terminal is disconnected.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Engage the claw and occupant classification ECU.


d.

Connect the connector to the occupant classification ECU.

NOTICE:
·

If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.


·

When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.


·

When replacing the occupant classification ECU, replace the bolt with a new one.




Hide 2.INSTALL OCCUPANT CLASSIFICATION ECU (for Power Seat)

a.
B194816

Check that the ignition switch is off.


b.

Check that the negative battery (-) terminal is disconnected.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Engage the claw and occupant classification ECU.


d.

Connect the 2 connectors to the occupant classification ECU.

NOTICE:
·

If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.


·

When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.


·

When replacing the occupant classification ECU, replace the bolt with a new one.




Hide 3.INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

a.

Install the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).


Hide 71100S 4.INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

a.

Install the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)