Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)
Remove the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).
71100S
4.REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)
Remove the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
5.REMOVE OCCUPANT CLASSIFICATION ECU (for Manual Seat)
Disconnect the connector from the occupant classification ECU.
Disengage the claw and occupant classification ECU.
6.REMOVE OCCUPANT CLASSIFICATION ECU (for Power Seat)
Disconnect the 2 connectors from the occupant classification ECU.
Disengage the claw and occupant classification ECU.