Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235859 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62312B 5.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 53601 8.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55046A 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 33504F 10.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58804A 11.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 58805C 12.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 58910C 15.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 89170 17.REMOVE AIRBAG SENSOR ASSEMBLY

B192367E01
1.442,1.104 1.843,1.260 0.401,0.156 10 Lever 1.069,0.951 1.41,1.181 false

CAUTION:

Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.


a.

Pull the lever down and detach the connector holder.


b.
B192369

Remove the 3 bolts and remove the airbag sensor.