Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Driver Side)
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235860 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  INSTALLATION  


PROCEDURE

Hide 73900 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.
B225998

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Attach the 2 claws to install the DLC3.


c.

Install the 4 bolts to install the instrument panel airbag.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 55046A 2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.CHECK SRS WARNING LIGHT