Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the LH side and RH side.
The procedure listed below are for the LH side.
87510R
1.INSTALL SEATBACK HEATER ASSEMBLY
Set the seatback heater with the name stamp side facing the seatback cover.
Install the seatback heater with new 8 tack pins.
Do not bend or fold the seatback heater assembly.
71077S
2.INSTALL SEPARATE TYPE REAR SEATBACK COVER
3.INSTALL SEATBACK COVER WITH PAD
Attach the hooks to install the seatback cover with pad.
Using hog ring pliers, install the seatback cover to the seatback frame with 2 new hog rings.
Connect the connector and Attach the wire harness clamp.
79013
4.INSTALL NO. 1 SEATBACK COVER SUB-ASSEMBLY RH
71931B
5.INSTALL REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
72057
6.INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH
72615C
7.INSTALL REAR SEATBACK LOCK STRIKER COVER
72927
8.INSTALL REAR SEAT CUSHION UNDER COVER RH
71629A
9.INSTALL REAR SEAT CUSHION HINGE COVER RH
71691E
10.INSTALL REAR SEAT CUSHION HINGE COVER NO. 1
71701B
11.INSTALL REAR SEAT BACK BOARD SUB-ASSEMBLY RH
71940A
12.INSTALL REAR SEAT HEADREST ASSEMBLY
72995B
13.INSTALL NO. 1 SEAT CUSHION COVER RH
14.INSTALL REAR NO. 1 SEAT CUSHION ASSEMBLY RH
71691H
15.INSTALL REAR SEAT CUSHION HINGE COVER NO. 2
71692H
16.INSTALL REAR SEAT CUSHION HINGE COVER NO. 3
72735
17.INSTALL REAR SEAT RECLINING RELEASE LEVER
72572B
18.INSTALL RECLINING ADJUSTER KNOB CAP RH
19.INSTALL REAR NO. 1 SEAT ASSEMBLY RH
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY>INSTALLATION).