The air conditioning harness connects the air conditioning amplifier and each servo motor. The air conditioning amplifier supplies power and sends operation instructions to each servo motor through the air conditioning harness. Each servo motor sends the damper position information to the air conditioning amplifier.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1497/97 | Communication line error or open | ·
Air conditioning harness ·
No. 2 air conditioning harness ·
Cooling unit damper servo sub-assembly ·
Air mix damper servo (for passenger side) ·
Recirculation damper servo ·
Cool air bypass damper servo ·
Air mix rear damper servo ·
Mode rear damper servo ·
Air conditioning amplifier ·
Harness or connector |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Port | Control Range | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor pulse | Min.: 0, Max.: 255 | - |
| Air Mix Servo Targ Pulse (P) | Passenger side air mix servo motor pulse | Min.: 0, Max.: 255 | - |
| Air Outlet Servo Pulse (D) | Driver side air outlet servo motor pulse | Min.: 0, Max.: 255 | - |
| Air Inlet Damper Targ Pulse | Air inlet damper target pulse | Min.: 0, Max.: 255 | - |
| Cool Air Bypass Pulse | Driver side cool air bypass pulse | Min.: 0, Max.: 255 | - |
| Rear Air Mix Servo Targ Pulse | Rear air mix servo motor pulse | Min.: 0, Max.: 255 | - |
| A/O Servo Pulse (Rr D) | Driver side air outlet servo motor pulse | Min.: 0, Max.: 255 | - |
Arm of the servo motor selected in the Active Test moves smoothly
According to the test, proceed to the next step.
| Result | Proceed to |
|---|---|
| One of the front servo motors is malfunctioning | A |
| All of the front servo motors are malfunctioning | B |
| One of the rear servo motors is malfunctioning | C |
| All of the rear servo motors are malfunctioning | D |
| All of the servo motors are malfunctioning | E |
A
B
C
D
E
According to the test, proceed to the next step.
| Result | Proceed to |
|---|---|
| Only the air mix damper servo (for driver side) is malfunctioning | A |
| Only the air outlet damper servo is malfunctioning | A |
| Only the air mix damper servo (for passenger side) is malfunctioning | B |
| Only the air recirculation damper servo is malfunctioning | C |
| Only the cool air bypass damper servo is malfunctioning | D |
A
B
C
D
Replace the cooling unit damper servo sub-assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Replace the air mix damper servo (for passenger side) (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Replace the recirculation damper servo (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Replace the cool air bypass damper servo (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Replace the air conditioning harness.
Since the air conditioning harness cannot be inspected while it is removed from the vehicle, replace the air conditioning harness with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
According to the test, proceed to the next step.
| Result | Proceed to |
|---|---|
| Only the air mix rear damper servo is malfunctioning | A |
| Only the mode rear damper servo is malfunctioning | B |
A
B
Replace the air mix rear damper servo (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Replace the air mix rear damper servo (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Disconnect the P9 No. 2 air conditioning harness connector.
Disconnect the H67 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H67-23 (RBBU) - P9-4 (RBBU) | Always | Below 1 Ω |
| H67-1 (RBUS) - P9-3 (RBUS) | Always | Below 1 Ω |
| H67-21 (RBUG) - P9-2 (RBUG) | Always | Below 1 Ω |
| H67-23 (RBBU) - Body ground | Always | 10 KΩ or higher |
| H67-1 (RBUS) - Body ground | Always | 10 KΩ or higher |
| H67-21 (RBUG) - Body ground | Always | 10 KΩ or higher |
OK
NG
Replace the No. 2 air conditioning harness.
Since the No. 2 air conditioning harness cannot be inspected while it is removed from the vehicle, replace the No. 2 air conditioning harness with a new or a known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1497/97 is not output | A |
| DTC B1497/97 is output | B |
A
B
Disconnect the H24 and H67 air conditioner amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H24-21 (B) - Body ground | Always | 11 to 14 V |
| H67-24 (+B2) - Body ground | Always | 11 to 14 V |
OK
NG