The mode rear damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal or reverse) based on the signals to move the rear air outlet damper to the appropriate position, which controls the air outlet modes.
Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1449/49 | Mode rear damper position does not change even if air conditioning amplifier operates rear air outlet damper servo motor | ·
Mode rear damper servo ·
No.2 air conditioning harness ·
Harness or connector between No. 2 air conditioning harness and air conditioning amplifier ·
Air conditioning amplifier |
Connect the Techstream to DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Outlet Servo Pulse (R).
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Outlet Servo Pulse (R) | Rear side air outlet servo motor target pulse /
Min.: 0 Max.: 255 |
Customized value displayed | - |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to the DTC output) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
A
B
(See pageVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE)
C
Disconnect the P9 No. 2 air conditioning harness connector.
Disconnect the H67 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P9-2 (RBUG) - H67-21 (RBUG) | Always | Below 1 Ω |
| P9-3 (RBUS) - H67-1 (RBUS) | Always | Below 1 Ω |
| P9-4 (RBBU) - H67-23 (RBBU) | Always | Below 1 Ω |
| H67-21 (RBUG) - Body ground | Always | 10 kΩ or higher |
| H67-1 (RBUS) - Body ground | Always | 10 kΩ or higher |
| H67-23 (RBBU) - Body ground | Always | 10 kΩ or higher |
Reconnect the air conditioning amplifier connector.
Reconnect the No. 2 air conditioning harness connector.
OK
NG
Replace the mode rear damper servo motor (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT>DISASSEMBLY).
Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a normal one.
NEXT
Clear the DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Repair or replace No. 2 air conditioning harness (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT>DISASSEMBLY).
NEXT
Clear the DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG