Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(w/o Air Cooled Transmission Oil Cooler)
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235916 CONDENSER(w/o Air Cooled Transmission Oil Cooler) A

HEATING / AIR CONDITIONING  CONDENSER(w/o Air Cooled Transmission Oil Cooler)  INSTALLATION  


PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

I104362

a.

Install the cooler condenser with the 2 bolts, as shown in the illustration.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)

NOTICE:

Do not damage the cooler condenser when installing the condenser.


HINT:

If a new cooler condenser is installed, add compressor oil to the condenser as follows.


Capacity:

Add 40 cc (1.35 fl. oz.)


Compressor oil:

ND-OIL8 or equivalent.



Hide 88710 2.CONNECT AIR CONDITIONING TUBE ASSEMBLY

I104360

a.

Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on to the air conditioning tube.


d.

Connect the air conditioning tube on to the cooler condenser with the 2 bolts.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 88711 3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

I104359

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on to the discharge hose.


d.

Connect the discharge hose on to the cooler condenser with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 16400 4.INSTALL RADIATOR ASSEMBLY (for 3UR-FE)

a.

Install the radiator assembly (See page Engine / Hybrid System>3UR-FE COOLING>RADIATOR>INSTALLATION).


Hide 16400 5.INSTALL RADIATOR ASSEMBLY (for 3UR-FBE)

Install the radiator assembly (See page Engine / Hybrid System>3UR-FBE COOLING>RADIATOR>INSTALLATION).