1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
52119A
2.REMOVE FRONT BUMPER COVER
Remove front bumper cover (see page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL).
32907A
3.DISCONNECT OIL COOLER HOSE
Using pliers, grip the claws of the clip and slide the clip.
Disconnect the 2 oil cooler hoses.
16400
4.REMOVE RADIATOR ASSEMBLY
for 3UR-FE:
Remove the radiator (see page Engine / Hybrid System>3UR-FE COOLING>RADIATOR>REMOVAL).
for 3UR-FBE:
Remove the radiator (see page Engine / Hybrid System>3UR-FBE COOLING>RADIATOR>REMOVAL).
88711
5.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the discharge hose from the cooler condenser.
When removing the bolt, do not allow any tools to contact the pipe.
When removing the bolt, hold a part of the pipe near the connector.
Remove the O-ring from the discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88710
6.DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the 2 bolts and air conditioning tube and accessory from the cooler condenser.
When removing the bolt, do not allow any tools to contact the pipe.
When removing the bolt, hold a part of the pipe near the connector.
Remove the O-ring from the air conditioning tube and accessory.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88460
7.REMOVE COOLER CONDENSER ASSEMBLY
Remove the 2 bolts.
Remove the cooler condenser, as shown in the illustration.
88474
8.REMOVE COOLER DRYER
Using a 14 mm socket hexagon wrench, remove the cap from the modulator.
Remove the O-ring from the cap.
Using pliers, remove the cooler dryer.